This section includes computer errors and solutions.
Error
1- DWG/DXF save error
Turkish
English
2- StaUpdate error
3- Sta4CAD Setup
Dome Example
Dome type slabs are introduced in this example. When defining domes, it is necessary to define carrier beams under the domes as in the example. The beams carry the reaction of domes to the structure.
Retrofitting Project Example
This is a retrofitting project example applied to a school building. The residential buildings must satisfy Life Safety performance level for the quake with 10% probability of exceedance in 50 years. For school buildings, the structure must satisfy Immediate Occupancy performance level for the quake mentioned, and it also must satisfy Life Safety performance level for the quake with 2% probability of exceedance in 50 years.So two separate analysis must be done and the quake factor must be adjusted from the General Building Data section. Also using "Building dead load sequential construction" option will obtain better results.
Dome/Vault/Cone Example
Dome, vaults and cones exist in the same example. The corners of the slabs' that will be converted to dome must be placed on a circle. Note that only the vertical loads are applied to structure, if the horizontal loads are important (ex: in flat vaults), additional hand-check must be applied.
Panel Grid Example
The panel members had to be continuous in vertical until the 12.0 version of Sta4CAD. Now they can be applied non-continuous as in the example
Tunnel Form Example
A tunnel-form example can be downloaded from here. The minimum percentage of reinforcement is lower in tunnel-form examples.
Brick wall building example.
In Sta4CAD, walls wihout reinforcement can ba designed accordin to Turkish codes.
30 years in the software engineering.
You Can Download Some Examples of Special Cases From This Section.
STA Steel
STA4-CAD